Ppg Paint
Ppg Paint
How to use PPG deltron dbu?
i recently bought some PPG deltron dbu from english color and im wondering what i should use to thin it and how do i know how thin to make it im new to painting and im painting a ninja 600. any info is much appreciated!
ok i know its bc/cc but when i bought it they mixed the clear in with the paint
Make sure you use a compatible primer (check the link below) sand the primer with 600 and then go over it with prep-sol.
The reducer you use depends on the temperature of your paint booth:
Cold Temperature (45 - 55°F) DRR1150
Cool Temperature (55 - 65°F) DRR1160
Medium Temperature (65 - 75°F) DRR1170
Warm Temperature (75 – 90°F and above) DRR1185
Hot Temperature (90°F and above) DRR1195
Reduce it 150% (1 part paint to 1-1/2 parts reducer)
Use a fine cone-strainer when you pour the paint from the mixing bucket into the gun cup.
Set the air pressure on your gun and adjust the gun for an even spray pattern. Test-spray some masking paper to make sure it doesn't run or splatter.
(Here's a couple good articles for ya: http://www.worldpath.net/~thompson/misc/pressure.htm and http://www.minitruckinweb.com/tech/body/0706mt_spray_gun_basics/index.html)
Your compressor should have a good air dryer on it or you will get fish-eyes. Set your air pressure on the gun to:
8 – 10 PSI at the cap for HVLP guns
35 – 45 PSI at the gun for conventional guns
(with trigger pulled)
Your first coat should be a light tack coat. The next two coats should be thicker color coats.
BTW, You know that's a BC/CC system right? You're gonna have to clearcoat it within 24 hours.
Be sure to use a respirator.
Edit: Most clearcoats require a hardner/catylist. If they mixed it with clear you need to call the place you got the paint from and find out if it needs a hardner, and what the mix ratio is.
Deltron basecoat doesn't require a hardener... just a reducer. It's possible that the reducer activates the clear but without knowing what kind of clear they mixed there's no way of knowing. Most Automotive finish stores have sales people who are very familiar with the products. Give 'em a call.
Good luck
 |
 PPG Omni AE Buckskin Acrylic Enamel Paint GM WA4866  US $51.50
|
 PPG Paint Omni AE Aero Gray Acrylic Enamel Car Paint US $33.95
|
 PPG Omni AE Black Cherry Acrylic Enamel Car Paint US $49.75
|
 1960 DODGE AND DART AUTOMOTIVE PAINT COLOR CHIPS PPG DITZLER US $10.25
|
 1964 Plymouth PPG Paint Color Charts 64 Fury Belvedere US $9.99
|
 1990 PORSCHE IMPORTED CAR PAINT CHIPS PPG US $9.95
|
 1960 Olds 88 Super 88 98 Paint Colors PPG Ditzler 60 US $9.99
|
 1987 PORSCHE IMPORTED CAR PAINT CHIPS PPG US $10.95
|
 1971 BUICK Auto Paint Chip Colors Sheet PPG Ditzler US $8.50
|
 NEW Metallic Copper SCP Auto dry Pearl Pigment HVLP PPG Paint SikCustomPaint® US $5.99
|
| Powered by phpBay Pro |
School of Auto Paint and Body - How To Paint Tri-Coat Paint Job - Three Stage
Leave a Reply
You must be logged in to post a comment.