Nylon Pry
Nylon Pry
Fork tube separation instructions for a '83 Honda Nighthawk CB550SC?
I still have the fork tubes mounted to the bike. I have removed the cap, spacer tube, washer, spring, damper bolt (from the bottom of the tube) and removed the damper and short spring. I have pried the dust cap (rubber seal) and slid it all the way up. There is a piece of plastic? or nylon? that is blocking the circlip(I assume). I do not have a manual for this bike but I can not get one for a few days, so the help would be great!!
Just pry the plastic ring up (nothing is holding it).
Perhaps it's stuck to the foam ring underneath it.
After you remove the circlip, the the fork tube and lower will have to be pulled apart.
The fork seal is in very tight.
Hold the tube in one hand and the lower in the other hand.
Push the forks together.
Yank them apart with force (a bushing inside of the forks will hit against the seal like a slide hammer).
They won't come apart in one pull.
Push them - in - OUT -in - OUT - in - OUT
 |
 5 PC NYLON PRY BAR SET DASH PANEL TRIM REMOVAL TOOL KIT  US $15.99
|
 5 pc Nylon Pry Tool Set Auto Panel Door Trim Remover US $16.00
|
 Jeep CJ Cherokee Nylon Auto Trim Dash Molding Tools Pry Bars US $24.00
|
 3x Nylon Plastic Spudger Component Pry Open Tool iPhone 2G 3G 3GS 4 4S iPod iPad US $9.95
|
| Powered by phpBay Pro |
BLACKHAWK! Small Pry by US Cavalry
Leave a Reply
You must be logged in to post a comment.